[ipxe-devel] NIC Drivers DEBUG=nii:3 output

[Geert Stappers]

On Wed, May 10, 2017 at 11:59:32AM +0100, Dean Westhead wrote:
> From: "Geert Stappers" <stappers at stappers.nl>
> Sent: Wednesday, 10 May, 2017 11:25:37
> > On Wed, May 10, 2017 at 10:38:18AM +0100, Dean Westhead wrote:
> > 
> > > I have attached here the output text from the command .... hopefully that is what you wanted !
> > 
> > That is output during _build_   the request is _debug_ output.
> > 
> > So rerun  ipxe with the ipxe.efi that was build with
> > 
> >     make bin-x86_64-efi/ipxe.efi DEBUG=nii:3
> > 
> > and capture the output. It should help with solving the original problem
> > of NIC not being detected.  Bonus points for replying below the text.
> > 
> Hello,
>
> OK ... got it now. I did wonder if I was expecting some debug output
> in the build process !
>
> I am not actually physically where the blades are installed so this
> is all being done remotely via the iLO.
>
> I am sure there is a better way to capture this output but as I am
> remote to them, I have put the screenshots into a word doc.
>
> The doc is attached here in the email. If this is no good I will see
> what other way I can get it captured.


The captures are now at http://stappers.it/meuk/
I think the interresting one is http://stappers.it/meuk/nii_debug_2.png


Groeten
Geert Stappers
-- 
Leven en laten leven