[ipxe-devel] NIC Drivers DEBUG=nii:3 output

[Geert Stappers]

On Wed, May 10, 2017 at 01:36:09PM +0200, Geert Stappers wrote:
> On Wed, May 10, 2017 at 11:59:32AM +0100, Dean Westhead wrote:
> > From: Geert Stappers , Sent: Wednesday, 10 May, 2017 11:25:37
> > > 
> > > That is output during _build_   the request is _debug_ output.
> > > So rerun  ipxe with the ipxe.efi that was build with
> > > 
> > >     make bin-x86_64-efi/ipxe.efi DEBUG=nii:3
> > > 
> > > and capture the output. It should help with solving the original problem
> > > of NIC not being detected.  Bonus points for replying below the text.
> > > 
> >
> > OK ... got it now. I did wonder if I was expecting some debug output
> > in the build process !
> >
> > I am not actually physically where the blades are installed so this
> > is all being done remotely via the iLO.
> >
> > I am sure there is a better way to capture this output but as I am
> > remote to them, I have put the screenshots into a word doc.
> >
> > The doc is attached here in the email. If this is no good I will see
> > what other way I can get it captured.
> 
> 
> The captures are now at http://stappers.it/meuk/
> I think the interresting one is http://stappers.it/meuk/nii_debug_2.png
> 

As text

NII NII-0000:06:00.1 could not set station address: Operation not supported (http://ipxe.org/3c6a4083)
NII NII-0000:06:00.1 issuing 09:801b ifnum 1
NII NII-0000:06:00.1 could not set receive filters 0x801b: Input/out error (http://ipxe.org/1d6a4a98)
NII NII-0000:06:00.1 issuing 07:0000 ifnum 1
Could not open net1: Input/output error (http://ipxe.org/1d6a4a98)
No more network devices