[ipxe-devel] SOLVED [was Re: sanhook timeout in spite of correct target + no ping]

[Oliver Rath]

Hi Michael,

Im writing so much ipxe-scripts, but now it was the first time i forgot
the "dhcp" command (undionly.kpxe) before doing anything else. Including
this all is running fine.
*headmeetswall*

Tfh!

Regards
Oliver


Am 31.01.2014 18:21, schrieb Michael Brown:
> On 30/01/14 19:46, Oliver Rath wrote:
>> In the same case:
>>
>> ping 192.168.10.254
>>
>> (it is compiled in) times out in ipxe).
>>
>> <snip>
>>
>> Furthermore i cannot ping the machine where ipxe runs although (seen in
>> config menu) the IP seems to be set.
>
> If you cannot even ping to or from the machine running iPXE, then you
> have a basic problem with connectivity.  All the information about
> sanhook timeouts, iscsiadm, etc is an irrelevant distraction.
>
> You need to find out why you are unable to ping the iPXE machine.  For
> a start, have you actually opened the network interface (using e.g.
> "ifopen" or "dhcp")?  What does "ifstat" show?  What does "route"
> show?  Do any of the counters reported by "ifstat" change when you
> attempt a ping (either to or from the machine running iPXE)?
>
> Michael